...all kinds of problems. Have it taken apart for a good cleaning and inspection. A dryer fire is no
...need a new bearing. if you lift the lid is going to be on the right side in the middle. and its not fun to replace so i would have a factory authorized company come out and do it. if you try to do it ...
...want to blow a thermal fuse. Kenmore dryer comes apart from the front, UNPLUG dryer 220V is not fun remove the lint screen remove the screws under the lint screen holding the case top to the ...
...isn't hot. Otherwise it runs fine. My Frigidaire gas dryer isn't hot. It seems to otherwise run fun, just no heat. Model No. is FSG747GES1 it could be either your ignitor(glow coil) flame sensor ...
...or three heat sensors in a dryer one on the vent one by the fire/drum and one sometimes just for fun. Make sure you follow the wires and check all of ...
...to change which way the door opens? denne, you can reverse the door swing. It's not really a fun job so you want to make sure to allow yourself some time. Email me at [email protected] and ...
Question about Kenmore Dryers
away after a couple minutes. Should I replace the belt? No. It might be your bearings. Kenmores are fun to work on for a novice mechanic. You're gonna need vice grips and sockets for this job
...on most dryers you have to take it completely apart, top, front and even the back sometimes. Not
...loosen the drum and tip it so I could put the belt on then had to put everything back again. Have fun but you can do
How do you change dryer belt? remove outer housing belt will be attached to rear of drum.Good luck its no fun
192 questions posted
Usually answered in minutes!
1,329 Questions
1,410 Questions
750 Questions
524 Questions
182 Questions
