Element Electronics FLX-1910 19 in. LCD HDTV "phillips base screws" Questions

...base. help You will need a phillips head screwdriver. There are four screws on the back of the TV that go into two rather long "legs" that go a few inches into the bottom of the TV. Just remove those ...

...base I have a dynex 37" DX-LCD37-09 and want halp removing the base not sure which screws to remove Remove the four small phillips screws facing the back of the TV/Base and the whole base will come ...

...to take base stand off The should from 4 to 6 screws near where the base & tv come together. They are either #2 phillips or torx(t-20 or t-25) screws. Unscrew and the base pulls out straight

...at the base of fairly deep holes. They require a #2 phillips head screw driver. Remove all of the screws and then get a friend to hold the base whild you pull the tv straight up about 6-7 inches. ...

base. There are 4 phillips head screws on the rear panel of the TV just above the base. Remove them, pull the TV from the base, and replace the screws in case you need to use the base in the future. I

...base off you will need a long phillips head screw driver to get the single screw inside the arm that is connected to the base loose. After that you can work the arm off and your stand will be ...

...to take the base off my son's 42 inch olevia 542-b12 trying to hang on wall There are 16 phillips head screws on the back of the TV above the base, remove all of them and the base just falls

base uses 5mm x 16mm 0.8 pitch screws. Flat heads with Phillips or hex socket work the best. They cost me $0.61 each at my hardware store. If you buy it as a part # 313912879931 it will cost you about

...screws that came with the tv base stand wright?U have a Phillip screw driver wright?Just put the base stand into the tv make sure all the screws holes lines up between the tv and the base stand ...

...base? Hello; There are always screws in the back of the set near the base or screws that go up through the bottom of the base. Most screws are recessed and can be Phillips or Allen type screws. ...