Insignia NS-LCD47HD-09 47 in. LCD TV "open standby mode tv without" Questions

...it off with no power for a day This is in effect performing a factory reset. and this may sound stupid and patronizing but is the TV being taken out of standby mode and actually switched on? ...

...standby mode without remote being touched and also can switch off at random times mid programme. Not same time all the time either, very random. Good day!!!!That problem is usually cause of faulty ...

...standby power supply and any signs of damage you can see---burnt parts etc. 3. almost all these sets the troubleshooting involves checking voltages on the main power board to narrow down ...

...open a fujitsu plasma tv on standby mode without a remote control If the TV is switched OFF with the remote control for the last time, you can't switch it ON again, without its remote control. If you ...

...standby power section. Might check fuse, R607, Q601, IC601, R612 and VDR601 (should show open). Continuous blink once a second, no pausing - No reply from the jungle IC301 (data bus is busy, shorted ...

...Open up the back of the TV indexing all the screws,take your time. Set your Multimeter on Voltage setting 600v or just voltage if it's autoranging!! Unplug the power cable going to the Power Supply ...

...standby mode. Hello, The power light may be flashing or if you are runing with a series light bulb it may be cycling on and off continuously. There may be a chirping or clicking sound from inside the ...

...standby 5vdc that is why the front LED is on but the 12 and 24vdc are not on due to bad circuits in the power supply or shorted out load that caused the 12/24vdc to be in shutdown mode. You do need ...

...standby mode. I did contacted FUNAI 3 times for any inputs to no avail. Perhaps if I have a way to pin point which boards are the problem, I can just replace the board. I am not a electronic ...

...standby after about 7 seconds. I have been able to reproduce this event a lot sooner by using an hair dryer to heat the back of the tv up (I managed to reproduce the event in about 15 minutes). One ...