Sanyo Split System Air Conditioner "mean shuts down" Questions

...shuts down what does error check p8 mean See this document for P8 code on Mitsubishi Mr Slim MXZ30TN... It is likely you can get the fix just from following the diagnosis steps 1-7. ...

shuts down after operation with a E4 error message. Hi, The E4 error in display its mean the wire sensor connector to thermostat is loose pls fix , or have a problem in PCB Board on thermostat, pls go

shuts down and I don't have a manuual to trouble shoot it. The heater warms up then shuts down and displays code "EE 2". I NEED TO KNOW WHAT THE EE2 CODE MEANS.ON YOUR FURNACE THERE IS A LIST OF ERROR

shuts off. Run light blinks 4x. Can turn unit back on and it will run another 30 minutes or so then shut off again. What's the code mean? Any ideas? Check web site for significance of the four flashes

...shuts down, 1 green ligt comes on than the other gren light comes on than it clicks oune yellow light flashes than the unit shuts down. Check the air filter, if its dirty it will short cycle. A ...

...mean? I have a manual and it only talks about the error, P1, when the water container is for. Says nothing about P2. The unit will just completely shut off and then the red light is flashing and P2 ...

...before, not sure why I waited 30 minutes and it restarted. if the compressor started and stoped means 1 thermostat need settings 2 compressor over heated due to low suction pressure need to check ...

...shuts off but condensor keeps running....gets very warm in the house . AC repar man came and checked motor which worked fine when he was here. Now it has stopped working again....HELP!!! check for ...

...down in the middle of the night. It beeps and a red light flashes on it. What does this mean? It means that condensed water has accumulated in the unit. In the rear, on the bottom right, there is a ...

...shuts down only to try again in a short while. The red light visible inside the furnace is flashing .I have tried resetting by shutting unit off at thermostat for a few minutes the turning on to heat ...