Question about Dryers
...DOOR switch...!! Visually inspect... bad = replace Good = cycle the switch** **(give it a couple of quick jabs with you finger to see if the light goes off/on... (because it might be "SHORTED" inside ...
...side. Locate and remove the three screws on the washer front that hold the door latch assembly in place. The whole assembly should come free from the washer front and be held by a plastic mounting ...
...side. Locate and remove the three screws on the washer front that hold the door latch assembly in place. The whole assembly should come free from the washer front and be held by a plastic mounting ...
...side that isn't making it into the catcher. I can see it through the holes. Any way to take that screen thing off and clean out? That lint may be covering the humidity sensor, which is why it ...
...door of the dryer and make sure that the drum can be turned freely by hand. If this is OK, then press the dryer power switch. The front fascia lights should now be on. Then press the start button. If ...
...see a white fuse top side. Two wires going to it. You can ohm it out or jump it temp. to see if the dryer starts. Also make sure the door switch is operating. Check the attachment. Catriver..post ...
...side of the door section, with the flat side against the door and the notches facing up (they will face into the dryer). Attach the hinge on the same side as the shield. 3 Set the top section aside. ...
door is closed, the power flows to the push to start switch. 2. styles. Older models you remove 2 screws from the bottom of the front panel, pull out bottom of the panel and drop down. Machine must be
side. CAUTION: It is recommended that you unplug the dryer BEFORE servicing the inside or cleaning. There are still dangerous voltages present even with the machine turned off. Suspected Components: 1
8 questions posted
Usually answered in minutes!
73 Questions
25 Questions
31 Questions
9 Questions
8 Questions