KitchenAid KGSK901SSS Gas Range "wire top oven" Questions

...TOP OVEN RANGE WENT TAKING OUT THE ELEMENT WIRING WAS BURN INTO,HOW DO I GET TO THE WIRING IN THE BACK OF RANGE TO CHECK IT OUT. Wall ovens usually need pulled from wall to access back wiring. There ...

...Top element 19 ohms, bottom 24. Found a yellow wire running from back of control panel down to where bottom element sticks through, but the yellow wire wasn't hooked to anything on the other end. I ...

...top stop working any help? please... Hi If your range/oven doesn't seem to work at all, check these: Fuse/circuit breaker Check to see if power is getting to the range/oven. Does anything turn ...

Wire burning smell whirlpool range. Happens when oven or top are turned on. Smoke come out under control panel. Had the same problem with my Whirpool range. Took off the rear panel and carefully ...

...a faulty oven sensor I have a Frigidiare Range with a glass top (see burners throug top). How do I keep the surface around the burners clean? The top looks marred from the first time I used the

...wire or loss of contact can all be done at back of range remove top and bottom cover sensor will be have 2 screws either in back or can be inside oven to remove sensor look for open wires or if ...

...60cm Ceramic Electric Double Oven.When i turn the top oven on it trips my fuse box. The hobs work fine, just this top oven. Can anyone suggest why this is happening? there is a short in the ...

top left back wall of the oven to see the sensor protruding out. Unscrew the 2 screws holding the sensor and CAREFULLY pull it out. Unplug the wire connector. Plug in the new sensor and CAREFULLY push

...wire, and required only a rewired wall socket to fix the problem. The steps will be to unhook the range, stove top, and/or oven, and check the wiring in the back of it, first the wall socket (take it ...

top oven lower heating unit isn't getting hot, I checked wires coming to heating element one side shows 120v but the other side does not, so I think whatever that wire hooks to is not allowing voltage