Hyundai Electronics Hyundai Elantra 2004 Stereo/radio Wire/wiring Harness "turn brake lights" Questions

...brake lites are on replace the bulb. Next ..turn off the lites and check the lites again. If all are off step on the brake pedal once and recheck the lites. If they are on the switch on the brake ...

...brake light switch if i turn the flasher on the brake light go off then come back on when i turn off emergency flashers make sure you have the right switch,right bulbs,and your flasher module my be ...

brake light switch works, turn signals work, four ways work, top center brake light works, but the brake lights do not work. tested a different light module, still nothing. RE PLACE BRAKE LIGHT SWITCH

...I have a 2004 Ford Ranger. The tail lights and turn signals are working. No brake lights. Fuses and bulbs are fine. had brake switch checked and it's ok. you have no voltage going to the switch ...

...brake lights work for a minute or two then not again you may have grounded them out with the turn signals if not you may not be getting the required power for the light according to the manufacturer ...

brake lights on Yesterday my battery light and parking brake light came on. What could be the problem? Blown alternator? Bad fuse? If bad fuse, where is the fuse box in the pax compartment? I couldn't

...right now u just have non ABS brakes, there about 20 diff faults that can turn the light on, the way u find out which one is the problem u have a ABS fault code test run by a brake shop or the

...brake is pushed the daytime running lights always in all cars should turn off ... to be honest you need to get a wiring diagram from the chevy dealer and follow the diagram to find out which part is ...

...brake light n turn signal doesnt then replace the bulb it's all in one Hi Anonymous. Systems like brake and tail lights are pretty much always serviced by separate fuses, so that one bulb blowing or ...

...brake, one for running lites and one for ground that one should be black in color. wiggle that wire and if it starts working replace the socket if not using a jumper wire find a good ground connect ...