...Bit late to help the owner of this question and yes it could be a carbie issue but also check the idle speed. If it has dropped out of calibration and is idling too low it will start then stop. Try ...
does trimmer head spin at idle this is a hard question ,ill start with the text book answer , NO the idle should be low enough to disengage the clutch and remove power from head . but in reality this ...
HEDGE TRIMMER IS EASY TO START AND RUNS GREAT AT HIGH SPEED BUT WILL NOT IDLE. ALSO IS SLUGGISH IN RESPONDING TO THROTTLE. Have replaced diaphraghm assemblies and fuel lines You have two adjustment ...
...on my echo hedge trimmer on the carb for the mixture, at the moment it does go but does not idle and feels as if starved of fuel when reving up,a bit tricky to start when warm. On an
...( Usually the H Mixture Screw). >>Now Setting the Air Mixture Screws: >>****Turn the Idle Air (L) and Main Air (H) Mixture Screws In Until SNUG **Do Not Jam** Then Reverse Both Screws
set idle 224L set idle page 19 of the manual found here : http://www.husqvarna.com/ddoc/HUSO/HUSO2009_USen/HUSO2009_USen__115138729.pdf
Hedge trimmer goes dead Will start and idle, but goes dead when I pull trigger to idle up Most likely a fueling issue but could be something else, more detail on the condition of the machine would be ...
the air filter isn't dirty. If the machine runs ok on high speed but cuts out while idling, the idle speed may be too low. There is usually an adustment screw for increasing the speed. If the fuel
my Echo SHC-212 will start and slow idle but when I give it gas it boggs and stalls. I've changed the spark plug and I'm using the proper mix. Any suggestions? I was thinking of trying to clean the ...
chain saw runs on full choke and a little on fast idle. Will not stay running, won't idle. Sounds like a carburetor issue. Chain saws get the &**^% beat out of them during normal use. This may just be
65 questions posted
Usually answered in minutes!
295 Questions
300 Questions
122 Questions
96 Questions
40 Questions
