Poulan 42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With 6 Speed "blades stop lower" Questions

...blades fine a way to stop blade from turning, put a socket with long handle and turn countercock wise, some will need a wench on nut at top of shaft to stop blade from turning, torque to 60 # on most ...

...lower the blades and could not. It moves down and springs back doing nothing to the blades. After pulling the mower up on my risers I looked and could not find a reason for the problem. My small ...

blades quickly when disengaging them) that may be stuck in stop mode. With the mower engine running.....have some one engage the blades while you look under at the belt system....is the engine driving

...lot of debris from under the deck and now the blades turn when the deck is high, but stop when I lower it below the fourth level. might need a new belt or bearings replaced or maybe grease the ...

...blades are designed to be set higher off ground.Iwas going to put a spacer between blade and adapter but couldnt.Is this normal for the husqvarna.the guage wheels are set completely off ground ...

stop. Jerks when you turn left or right too. Could just be the adjust tension of the belts? Also when I engage the blades it squeals very loud and then stops, but not all the blades are turning at the

Husqvarna Proflex 21 just stopped engaging the blades after bump over brick. Was working fine, on starting the next cut the engine goes well, lever works but no mower blades turn when lever lowered. T

...and decide to stop and put it in nuetral if the blades are lowered and pto engaged when you leave the seat the motor will cut off. if that isn't it make sure your spark plug is pushed all the way

My cutting blade stops working when it starts to cut in positions 1 &2 why is this happening? Were is the cutting belt adjuster? Thank jon the belt is warn and moving it to the lower positions it ...

...lower the blade deck, it cuts the lawn unevenly and very short. I hear no unusual noise from the area of the blade. I have looked to see if any of the adjustment mechanisms have been bent or changed, ...