Pool heater burners won't ignite. Shortly after turning on the pool/spa heater I hear a clicking noise and smell gas but the burners don't ignite and heat up. Could this be a bad flame sensor or ...
Question about Hayward Pool & Spa
...pool heater not lite, what is the most likely problem My pool heater sounds like it's trying to lite but won't. Sounds like it is lighting but does'nt there are a few things you can check. make sure ...
...pool heater burners will not ignite The pilot light stays on but the burners will not ignite.I have the manual but do not know if this needs to be tested with fluke meter with the filter on or off.I ...
Question about Pool & Spa
...pool heater that fails to i have a Pentair MiniMax NT 250,000 btu pool heater that failsto ignite burners. the ignition element heats up and glows. the deviceattempts to light the burners three (3) ...
...burners will not ignite, checked all switches seem to be working allright, still no burner ignition Possibly a flow switch not closed, or a limit switch open. May even be the pilot generator not ...
Question about Hayward Pool & Spa
pool heater pilot on, heat does not ignite burners we replaced the 3 switches. the pilot comes on but the 3 burners at the bottom never ignite and there is no heat. The gas is on, the pilot is on, but
LP gas That involves changing out the complete burner tray including the igniter/pilot assembly, burners and the gas valve. It runs deep into the cost of a new heater, (well over $1000, not installed)
flashback on startup when the burner ignites, It ignites with a "boom" enough to knock the front panel off of the heater. clogged heat exchanger, clogged burner orifices, blocked venting, improper gas
...pool heater Raypak gas pool heater ignites normally but 20-30 seconds after ignition flame flares up on right hand side You will need to pull the burner tray out and clean and blow out the burners. ...
...heater for pool heater- I set mode for pool set. enter-set temp at 82-temp number keeps flashing-press enter-goes back to fault 2 no ignition-sometimes temp stays-igniter shows up-clicks but burners ...
177 questions posted
Usually answered in minutes!
43 Questions
49 Questions