Question about Rheem Pool & Spa
...pool heater? In the header... Plumbing side And wire plugs onto heat / control assembly board. SNS indicates that the Temperature Sensor is out of range! There are two thermistors within that sensor, ...
heater will not fire has code #sns what is the problem? the water is 65 degree. SNS means the temp sensor is out of acceptable range. Could be the following: 1. Water temp is below 36 degrees F 2. The
display is reading sns. what does this mean? SNS 1) SENSOR IS FAULTY 2) TEMPERATURE IS ABOVE 110°F 3) TEMPERATURE IS BELOW 36°F It is one of the above situations
What does sns mean It won't try to lite. sns is code that comes up temp sensor failure
Question about Pool & Spa
...pool heat fires, then turned off and LED says sns. What is wrong model P-l400A-EN L400A-EN Natural gas fired I think sns means sensor, perhaps the over temp sensor is defective, that would cause the ...
SnS or maybe it's 5N5 shows up on my heater. It is a PR266A model. It will not heat up. What is the problem? This is only the 2nd season for this heater! water sensor failure
...pool heater on and blinks SNS, ROL and in top corner the service light blinks. Any easy solution rollout switch is open, and sns is a sensor failure. replace rollout switch, clean out vents, inspect ...
heater displays SNS - sensor failure. what do i do? sns occurs when sensor reads temps under 36 degrees or above 110 degrees. check temp of of water to verify.....may need a new water sensor
...sns on my heater SNS on Raypak heaters means the following: 1. Water temp is below 36 degrees F, or above 110 degrees F. 2. The sensor contains 2 thermistors. If they are more than 2 degrees aparts, ...
heater is not working I have power but the screen is showing an error message SNS. What do I look for what sensor is not working. Here is the link for the manual for your boiler. http://www.raypak.com
177 questions posted
Usually answered in minutes!
43 Questions
49 Questions