pool heater 206A. just replaced the unitherm governor, but it is still showing HL1. it will work for a while, then HL1 shows, then it starts again. what's wrong with it? Possibilities: 1-low water
Question about Raypak Pool & Spa
...the filter running it in recycling mode but I get the same results. Error HL1 -Bob- the heater is plump correctly?if yes assembly valve need replacement, if you by pass before dirt may be
in recycling mode .. . I get the same results. Check the bypass in the header for damage. HL1 along with the banging/popping is too low of water flow through the heater and the water is getting to hot
hl1 pool heater This issue sounds tricky. I recommend you callthe Raypak technical support at 800-947-2975 or 800-627-2975 and they should beable to help you figure this issue out. I hope this helps.
Raypak RP 2100 Model PR3335A-EN display service HL1 Also main power switch on side of unit needs replacing Electronic control will toggle from off but immediatley displays the HL 1 service code -- ...
...heater. when i turn it on it heats up and soon after it starts to shake and it shows error code HL1. i suspect its overheating but not sure why. could be a plugged heat exchanger due to insufficient ...
43 questions posted
Usually answered in minutes!
176 Questions
49 Questions