Question about Microwave Ovens
...Inverter 1200W). It stopped working:I press the Start and it doesn't start. Very briefly, the number 333 appeared on the display. What's wrong? How to fix it? Change control board or connections ...
...inverter, magnetron, and/or control board, or maybe one of those components has failed. Due to the lethal voltages used and produced in inverters, I do not recommend that an inexperienced person work ...
Question about Panasonic Microwave Ovens
...change the magnetron still not heating Anyone knows what is the problem with it ??????? Judging from the model and without looking it up I expect that unit has an inverter. If it is not the Switches ...
change problem. Clock is working. Shuts itself off in 2-3 seconds See if this describes what's happening: Put in time, push start and unit runs for 2 seconds, relay clicks, unit goes off. Cook time on
...change after you get the cover off it is the part in the yellow plastic box ...unsnap the box unplug the three set of wires unscrew the ground strap bend up the tab at the lower left side the same ...
Question about Microwave Ovens
...change from AC-DC. A bad large AC filter cap in most models inside the unit. A bad Magnetron or the inverter board connected to it that does the heating. typical diode Typical filter cap used--shapes ...
...inverter, magnetron, magnetron thermostat, controller, or thew wiring that connects them. There should be a "mini-manual" (tech sheet) hidden inside the unit behind the control panel or hidden on the ...
i changed the fuse and still no luck? The problem is a defective magnetron, or the inverter board, "if 7 years or less" and possibily the keypad control board. But cost should be considered
...inverter is no good either. That would be a huge amount of bad luck. The microwave is only 16 months old. The model is GH5184XPB-7 Hi, F7 Microcomputer Board Failure: Change the microcomputer board. ...
16 questions posted
Usually answered in minutes!
80 Questions
95 Questions
80 Questions
69 Questions
56 Questions