Panasonic NN-T888S Convection/Microwave Oven "door micro switch" Questions

...door micro-switches pin or lever get stuck or broken. You can take couple pictures before remove wires or micro switches You can buy these switches for about 3-7 dollars online. Some web sites have ...

...micro switch) is normally closed, (open when the door is closed) however if it remains in the closed state when the door is open you will have a short circuit with the Primary Micro switch. The ...

...micro switches in the door is stuck ( faulty ) there are normally 3 switches so after removing the lid open and close the door and you will see the door latches pressing in the button of the micro ...

...door. This time micro is DEAD - not even a light working. My computer is on same circuit and is back up and running. I've been reading a number of other problems and solutions that seem similar and I ...

door micro switches are open or shorted..the micro switches tell the unit the door is closed and safe to use.the micro switched are marked normally open or closed..take note when replaceing them..also

...micro won't work. seems like the door is open, but it is latched. is there a switch that tells the control panel the door is shut? Yes. One of your door switches is not working. It could be an ...

...the door lock If the micro switches for the door are not aligning up then the microwave will think the door is not closed and won;t start so I would make sure the door micro switches are lined ...

...door is open. It is micro switch when you close the door, the door latch push in a button on the micro switch take lid off open and close the door and see if you can spot a button not popping out ...

...to make contact with the door latches when the door closes. Adjust the position of your switches. any suggestions on "how" to adjust said micro-switches?  Disassembly guides?

...door micro switch is faulty, or a terminal lug pushed onto one of the switch terminals has a bad contact. Most microwaves have 3 switches, or 4 in one I have. I've replaced a few of these switches ...