Eureka Smartvac 4870 Bagged Upright Vacuum "replacing roller brush belt" Questions

...brush roller. Lesser tension diminishes the brush roller's turn rate, speed and can lead to the brush roller not turning at all. The next thing to check would be the brush roller itself. Usually you ...

...replacing the roller/brush head. Hopefully you will find this useful. MY ROLLER WON''T SPIN EITHER, AND I FOUND IF YOU TURN THE MACHINE ON, THE BRUSH CONTROLLER SHOULD CHANGE. I THINK I'LL TRY THE ...

...roller brush. There will be four screws (usually phillips head), remove the screws and the base plate will lift off. You now have access to the roller brush and belt. Lift the roller brush up and ...

...roller brush stops when the brushes hit the carpeting, please just use the clarification request form here on the Fixya repair page. I will then be happy to walk you through a little more advanced ...

...brush roller and a silver shaft directly back from where the belt would ride. Remove the brush roller, place the new belt, Dirt Devil Style 5 ( see link below ) on to the shaft. Then insert the brush ...

...Roller brush was turning sporadically so I removed the bottom plate to see if belt(s) were broken only to find they are both fine. Could the roller brush belt be stretched? If so how can I tell? Also ...

...brush roller is rotating. If it is, then the belt is not broken. Depending on how much use your machine has had, it's quite likely that the brushes on the brush roller are worn to the point where you ...

brush roller. Remove old belt. Slide new belt over the motor pulley, first. Then slide roller through new belt (if self propelled model, slide roller through the small belt, also) and slide brush

...brush plate underneath and pulling the roller out. Replacement belts are available on-line or may be available in hardware stores.Fit the new belt over the steel motor spindle first, then place the ...