getting too loose. I tighten down the bar as tight as I can but the chain keeps getting loose. Sagging too far below the bar. I have to tighten it every few minutes. Make sure the bar is positioned on
Problems with the 350 husqvarna bar. 350 husqvarna bar oil is pumping out fine. Oil passage ways in bar are all perfectly clean and free of obstructions. Oil just doesn't get into the bar oil holes. ...
put chain back on Hi Eric, You will need a ratchet and the socket that fits the nuts holding the bar on. Also a screwdriver that matches the bar tensioning screw. The tensioning screw runs along the ...
no oil to bar bar get hot little or no oil get to bar The first thing to check is to see if the oiling hole in the bar is clear of sawdust a debris. Remove the chain and bar completely and make sure ...
...getting oil from the resovior to the chain/bar. If you cleaned the obvious area and the chain is not coated with oil, you may have a clog further up (inside) the oil delivery mechanisms. Also, drain ...
how do i get the chain back on the bar??? It depends on how it came off. Was it way too loose? Undo the two nuts holding the bar to the motor, slip the bar off the tapered tang that is part of the ...
Question about Husqvarna Garden
I have a husqvarna 435 with I believe a 16 inch bar. Can the bar be replaced with an 18 inch bar? Yes, as long as the replacement bar's oil hole lines up, and you get the right length chain. From ...
...bar with your fingers it should just half lift out of the guide slot. The chain will loosen a little more as the chain heats up during use. Don't forget to fully tighten up the clamp nuts when ...
...getting bar oil. Where do I start? The oil slots get clogged with sawdust. Take the bar and chain off. on the bar between the mounting holes there are two holes they are connected to the groove that ...
Question about Garden
...getting bar oil to the bar any sugg. ***** 450 rancher just changed bar and chain used 1 tank of gas but no bar oil was gone wondering if it can become plugged or pinched tubing or what yes it can ...
3 questions posted
Usually answered in minutes!
1 Questions
5 Questions