Homelite ZR10926 16 Chain Saw "wont pull" Questions

to much fuel in cilinder in primimg pips have air and dont wont start Never pull the starter more than 3-4 times under full choke. Pull 3-4 times on choke, push in to half choke and pull, should start

...Wont start. Has spark and gas flow. Hard pulling when spark plug in and pulls easy when spark plug out. Could it have something to do with muffler? quick check would be to pull muffler from engine ...

...wont pull. not even a little bit. the cord mechanism itself is working fine but when on the unit wont pull. i was using the saw and the chainbrake triggered. the saw shutdown. i reset the brake and ...

wont allow one to pull starter cord out , or is very tight feeling , try taking out the spark plug and pulling it then, if still wont go , it looks like it may have been run without enough oil mixture

...wont idle after warmedup When you pull the trigger on your saw lhile looking near the carb you will see the throttle plate moving back and forth as you pull it. The end of it usually rests against a ...

...wont start when hot I suspect your warm start procedure is the fault, the manual is not correct IMO. Any choke on a warm engine causes flooding, try this, if no better post back or return it for ...

...wont pull then seems it was overheated and now piston is fused to cylinder wall , if it does allow u to pull it , ck your reed valves in head seems there not releasing when they should also have a ...

i have a mcc1840b pull start wont grab,rope just pulls out easy ! Change the rope pull system.It comes in a one piece and is easy to install.

wont even pull at all,tried the electric start and wont turn over,,just wondering if its done.Should I even get it looked @ or am I wasting time and money,, Most of these engines have a low oil switch

...pull cord wont pull start I pulled cord a couple times (wasn't to easy) and on the third pull I couldn't budge it. Some saws with autotmatic oiling will leak bar oil into the cylinder and cause this. ...