Desa International Reddy Heater 200,000 BTU Kerosene Forced-Air Heater #R200BT "kerosene forced air adjustment" Questions

kerosene heater it powers up and thats it turn the power off to reset it nothing Hi, Here are a couple of tips that I wrote that tell you how to troubleshoot aTorpedo or Reddy heater... Reddy Heater -

reddy heater 60000 btu kerosine heater wont stay running, Blows a cloud of smoke and dies it either has too much fuel or not enough air. you will have to adjust both to figure out which is the culprit

operates 5 seconds then burner goes off How do I adjust nozzle pressure? Im not sure how to adjust the nozzle pressure, but mine was not getting enough pressure because the air filter had plugged up ...

i have a R60A Reddy heater multi fuel it has two adjustments on the back what are the for and how do i adjust them i think i have them screwed up Hi, Here are a couple of tips that I wrote that tell ...

Reddy Heater 60 starts runs short time then shuts off acts like it is out of adjustment when first started and i can't find my owner's manuel Fuel filter

Ready Heater 60 wont start. Fan runs for about 5 seconds and then stops. Check the wires for good connections. If the connections are good, then check the adjustment for the ignitor (sparker or ...

heater starts, fan runs, injecting fuel but won't fire up Hi, Here are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater... Reddy Heater - Troubleshooting ...

reddy heater 60 starts runs a short time and cuts off Hi, Here are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater... Reddy Heater - Troubleshooting Torpedo ...

It will run but then will smoke terribly and cut off. Hi, Here are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater... Reddy Heater - Troubleshooting Torpedo ...

...air adjustment. sounds like you have been working on the fuel side already. You may check the orfice to see if it is partially blocked, use a safety pin and gently **** it out. also check the burner ...