Fender Frontman 212R 100W 2x12 Guitar Combo Amplifier "drive channel" Questions

...drive" channel, the drive knob controls your gain. In both channels, the "master" knob limits how loud the amp will get. Most likely, you are on the drive channel, so the volume knob will have no ...

...Drive channel you need to use the Drive control AND the MASTER volume control. When the Drive channel is active, the Channel Indicator lamp should be RED indicating the Drive Channel is active. The ...

...drive channel the amp makes a loud popping noise. It does not make the noise switching from the clean to drive just from the drive to clean. What I have tried so far: Different cords and different ...

...A with a grounded cable will destroy the channel A amp. Use the 1/4 inch MAIN L & R jacks with balanced lines to active speakers. You can drive several active speakers from each of these

...drive channel is on when my hotrod deluxe is on the on board drive channel (the normal drive not the "more drive" function) it makes a loud hum and the guitar tone sounds like their is a really bad ...

drive channel, and there is a strange crackling on the clean channel. i dont know if its the tubes, the speaker, or electronics. Using a common lead pencil, gently tap on the smaller tubes in the unit

...sleeve to tip. This confuses the diodes in the foot switch, making them think the drive channel is engaged. A new wire (mono jack to mono jack using speaker cable not guitar cable)will fix the ...

...drive channel. if footswith is plugged in, then it turns on in the clean channel, but after switching in drive it is impossible to switch it back in clean channel. What could be wrong? Swith position ...

...channel works fine, drive & more drive VERY low volume, like a headphone across the room w/ all 3 volumes at 10. LED works fine in drive/more drive. All same w/ footswitch, different 12ax7's. ...

drive channel. gets worse in more drive. Plays fine in clean channel. Drive channels do not seem to work. Amp is Hot Rod Deluxe 40W The thing you can try is to swap tubes V1 and V2 which are 12AX7's..