Homelite ZR40502 Factory-Reconditioned 26cc MightyLite 20" Gas Hedge Trimme "hedge trimmer runs 1 choke" Questions

...hedge? Have adjusted high and low jets after warm up to where it runs great. Not new at this, retired marine machanic. Joe Sounds like fuel tank vent problem , air has to get into tank sometimes its ...

choke on You will need to take to a shop and have the technician adjust the carburetor. Plus I recommend mixing your fuel mixture at 40:1(3.2 oz 2 cycle oil to 1 gallon of gas) instead of the 50:1(2.6

hedge trimmer that will start fine but only run for 30-40 sec. in the "full choke" position before stopping. It will also stop if I try to give it gas. What should I do? Basics to check: 1) Spark plug

...trimmer. I have changed the plug, cleaned the gas tank, checked the lines and still can't get it to run when i accelerate it. I can keep it running a little bit by manually opening and closing the ...

...trimmer with the attatchments. It has never run well since purchased several years ago. At best it will start and I have to run it in the 2nd choke position and hold the trigger just right. At worst ...

...1 and use two stroke oil for strimmers or chainsaws. Firstly check the high-tension lead to the spark plug isn't loose. Remove the spark plug and place the body of the plug against the engine so ...

...hedge trimmer and it still dogs out when I try to get it to full RPM's, sometimes even half choked. The spark plug and the gas are fresh. It runs worse now that I've done the repairs! What am I ...

...hedge trimmer refurbished and used it once. It ran like a champ and I put it away. The 2nd time using it some month later, it will only run with the choke open full. Very Rough, runs rich, black oil ...

Hedger wont run unless it has choke on Sounds like the carb is lean. Back out the adjustments 1 quarter turn and work from there. Also make sure air filter is clean.That should get ya going.

...1 take off the air filter case you'r carb will be under it 2 move choke lever to full choke the float should be closed move to to half choke there should be a small gap then move to run float should ...