Honda 25cc 4-cycle Mini Tiller "tines turn stop" Questions

tines to turn, but with virtually now power - just setting them to the ground will stop them from turning...lift them from the ground and they will begin turning again. If clutch is released they will

...turn the tines it feels like something is grinding internally. Honda engine runs fine. I do not have a repair manual. Are they available. Does it sound like a transmission problem? Help! My seeds are ...

why did my tines stopped working my tiller was working, after 1 swip the tines stopped workin so i put a new belt on and they still don`t move. Hello, Did you notice if the tines moved when you turned

...it is difficult to turn the tines with the drive engaged to the engine. The only other option is to disassemble the transfer case to see what has gone bad. Please be careful testing it. Good Luck, ...

...by adjusting the 10mm adjusting nut,this will correctly set the idle #2) adjust the idle adjustment screw talked about above till the tines dont turn with throttle set at idle or lowest speed ...

tines, quit pulling, will turn if you hold the front end up, but put it down and they stop. need diagram or manual of tiller I had the same problem. It turns out the gear box was bone dry. Remove both

...tines will almost stop turning and the motor tries to bog down and go dead. After awhile I can start tilling again with the same results again, very aggraviting. Any help will be greatly appreciated. ...

...tines touch ground they stop turning. i have adj. clutch to max. made no difference....gabin The drive gear inside the transmission could be stripped. Have you check for drive pins located on the ...

Tines don't turn I JUST BOUGHT A USED MAXIM TILLER MODEL GA50B/GM50B and I ran it for five minutes and the tines stopped turning, belt pulley is turning. Is there something besides a broken chain I ...

...tines only turn untill they touch the ground, then they stop. does anyone know how the centrifugal(?) clutch works? does it have some kind of pad on it or is it steel on steel? the centrifugal clutch ...