RTO 1/2 Hp 1" Electric Centrifugal Water Pump Garden Pond "pump motor failed" Questions

...PUMP AND MOTOR IS 10 YO. It could be the capacitor again, but most likely if it stopped while running, its not that, unless you had a brief power failure. The motor may have a built in thermal ...

...pump and motor and look for signs of rust from a pump seal leak. If you are not familiar with testing these parts your best bet would be a local electric motor repair shop to see if the motor can be ...

...pump and motor) are failing. You can try charge pressure adj to make it work better. Model number will tell me where to direct you. The problem is not likely a low charge pressure setting. the pump ...

pump or the motor. about 15 yrs old at this point with moderate use (6-8 hrs/day) do i need a new motor or should i rebuild the pump unit? thanks anyone jim sounds like the bearings m8 would be better

...pump and motor and look for signs of rust from a pump seal leak. If you are not familiar with testing these parts your best bet would be a local electric motor repair shop to see if the motor can be ...

Pump plugged in to ground fault receptacle trips the breaker. When plugged in to non ground plug works fine. Any suggestions for repair? If by "trips the breaker" you mean the GFI then you are leaking

...pump motor to overheat and shut off to avoid permanent failure. The motor is likely failing. It may be a small part such as the capacitor or the starting switch, but could also be more severe such as ...

it seems that the pump that sprays the water has failed. The motor runs, but the pump isn't pumping. I will be taking it apart to see if it's clogged or if the impeller is broken. Good luck with yours

pump will not start on low speed I have taken it to a motor shop in ottawa ontario canada they tell me that it will not start on low. they say it will only start on high speed then a relay switches it

...pump and motor and look for signs of rust from a pump seal leak. If you are not familiar with testing these parts your best bet would be a local electric motor repair shop to see if the motor can be ...