sensor has not been disconnected from the board or at the thermo-well end. If it was connected disconnect and reconnect from the board.Reset the spa.If that does not work you'll want to purchase a
...thermo sensor.not much left to replace You didn't indicate your exact model. There are different versions of the H200 series. If it is milivolt then there is no electric, Must have correct milli-volt ...
...this serviced 2-3 months ago and it worked fine twice. Any ideas on how to fix this? Thanks! try to replace the thermo sensor it is located on the left side of tghe unit and has 3 wires running to
Question about Pentair Pool & Spa
The furnace short cycles. Number one sounds like a board issue or if the pool is on automation the temp sensor. Number two sounds like the thermo regulator which is located in the inlet/outlet headers
...temp regulator and hi limit sensor, the only thing I can think of is faulty Harwil flow switch, is this likely and can you test it? sounds like thermo in pump is bad need a new recirculation ...
Question about Sta Rite Pool & Spa
...down. The red light is flashing 3 times - "ignition lockout" this is typical of a dirty flame sensor.your model does not have a thermo couple.remove sesor and clean with steel wool or fine emory ...
...a few minutes the automatically shuts off sounds like the thermo sensor is bad or heater is overheating and therm is doing its job you might have to clean it out or if that doesnt work need a new ...
...for about 4 or 5 seconds and goes out. This process is repeated 3 times then faults out, I have changed the flame sensor with no change. thermo coupler. cheap and easy. does it hold a steady
Question about Desa International Pool & Spa
...the remote but if I set the temp to 74 it passes that temp without turning off Bad thermo switch ...
38 questions posted
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions