...filter area. You need to move about 24 gallons a minute to achieve the 6 hour turn over rate. Continue your research with these figures at hand. Thanks for your interest in FixYa.com. If you found ...
...24 hours a day at that rate during the open season. Turn over rate means all the gallons of the pool should go through the filter in 8 hours, or all the gallons should go through the filter three ...
...24 hours to properly dissolve and then you can program your unit. If large pool, start at 10 to 12 hours pump with 8 to 10 hours chlorinating.Check daily for chlorine level and adjust from there... ...
Question about Intex Pool & Spa
24 hours, added more salt, then started the start up process. Still only would go to pump light and then to sleep light. Only code it gave was low flow and we changed the filter. Still no middle light
...24 ft round above ground pool. 13500 gla water. We put in 10- 40lb bas of pool salt and have ran the system for the 12 hours and the pool is still green. Barely showing any salt in the system. I ...
...24/7? Usually, my pump is off during use by swimmers....manufacture recommends running pump in 4 hour increments as that is how long it would take to cycle the entire pool. After swimming pump is ...
Question about Intex Pool & Spa
...24 hours after adding salt to start the salt pump. Might turning it off (I already have of course) and waiting 24 before turning it back on help. You may think you have good flow, but the sensor that ...
...hours. The pump and filter are then sized for that required flow...Assuming the pool is an above ground ~4' average depth then total gallons would be about 24,000 gallons. For an 8 hour turnover ...
Question about Intex Pool & Spa
...24 hours later, so in my case, it will start the next day at 6:30 am... So i have have my Filter/pump come on 1/2 hour before the salt system comes on and it goes off 1/2 hour after the salt system ...
3 questions posted
Usually answered in minutes!
1,045 Questions
287 Questions
93 Questions
43 Questions
29 Questions