Intex Automatic Salt Water System for Above Ground Saltwater Pool "pool indicators" Questions

My Mr Zippy moves throughout the pool, but constantly gets "stuck" against the wall. With these pool cleaners, I would first check your Star Control settings. It could definitely be a ...

how do I use pool pulse? From the users manual for these pool cleaners: The Pool Pulse is a flow meter that measures the volume of water flowing through your Zodiac cleaner. It must be used to ...

When I turn on the pool, the pacer works for about 5 minutes then just gets stuck on the wall. If I turn off the pool and reset, it starts again then stops. How can I decrease the suction or adjust ...

Ready to Burst? I have a working 13 year old FNS Plus. Recent inpection by pool guy showed that the surface could be indented by a fingernail. He said that indicated the filter could burst as the ...

how do i convert motor from 120v to 220v you should have a label on the pump that shows the connections. 120V=low voltage 220V=high voltage. Here is an example of a label: Conect the internal motor ...

My zodiac zippy will not move in the pool. Please help. Make sure that your pump is on and that your filter is clean and not clogged. You will also want to check your water flow with the Star Control ...

Why does my Flow rate indicator indicate no flow Pool works fine and actual flow seem good but sensor reads no flow you may have a bad flow sensor or if recently changed, it may be in the wrong ...

indicates "waiting" and will not show menu indicates "waiting" and will not show menu try turning off rs system turn off pda turn rs system back on then turn on pda reboot

...for my intex salt water system. What side of pump does it attach to? You have an inlet side, (where pool water is brought into the pump), and is typically the lower of the two. Then you have the ...

sand is being pumped into the pool This usually indicates a broken spider gasket in the top valve. Your local pool dealer should have a replacement. it is simple to change, just remove the screws at ...