...sensors when in the heater are located typically above the inlet/outlet header. There will be some disassembling required to access it in this case. If it is in the heater and you need more help, ...
heater fires and shuts off repeatedly. reads CHF. Has good flow. error code should be inside heater make shure you have adequate gas pressure also sounds like bad flame sensor when flame sensor doesnt
...and needs to be reset if over 30 degree check temp sensor if reading incorrect will keep shutting heater down or will not water up to full temp usually ohm out about 78ohms if temp sensor is ok ...
...sensors mounted in the top of the heater tube one at each end. Follow the wiring from the sensor to the plug(s) on the PCB and check that the connections are good, they have a habit of devekoping a ...
the heather computer indicates:Flow and does not come on Without knowing what heater manufacturer or model, or whether this is a burner style furnace or heat pump, I would surmise a guess that you ...
...at 104 degrees and continues to heat to 109 degrees and then shuts off. Is there a reset for the heater? Steve YOU CAN RESET THE PANEL ON SOME HEATERS HOWEVER WHATS GOING ON IS ONE OF THE
Z110 jacuzzi heater keeps cutting off after 30 minutes. Changed the heater, the pressure switch and tried running with the high limit sensor pulled out of the housing. The water temperature needs ...
I have a RP 2100 Raypak Pool Heater Model number C-R185-EN installed about 1996 and used very little through out the years the front service light is on-- red --the back circuit board fault shows a ...
106 questions posted
Usually answered in minutes!
55 Questions
47 Questions
21 Questions