...water inlet fault-check inlet valve, check inlet hose not kinked 7flash=flow meter failure (flow meter measures water intake volume-large plastic weir located on left hand side of machine-reomve side ...
Aquastop, checked water flow (good), cleaned little filter (it was clean) and reconnected as per instructions in manual. Still no go. I understand that it means "filling" fault. Where else can I check
...water , it is not showing any faults so not sure what is wrong two things to check check continuity thru heater remove outer door panel and check for faults in wiring loom get back to me is these are ...
...check, the water level is still too high, then the program is interrupted, the fault code is saved and the drain pump is activated. Fault code F11 is also registered if heater relay 1K1 is not ...
.../ trip switches need to be checked. If water is going in and out ok, then it seems to be waiting to heat the water. It sees a fault - so just clears out. Heating elements do fail after a few
Question about Bosch Dishwashers
...check for heater, high limit or flow switch problems, start testing until heating starts. Using a meter with a current coil, measure current going into dishwasher. If current is ~ 11 A, then heater, ...
...water spray, indicates a fault with pump. but a common fault with pump is pump capacitor so worth checking this. capacitor is a cheap part. if pump is hot to touch or humming then this indicates ...
...check for heater, high limit or flow switch problems, start testing until heating starts. Using a meter with a current coil, measure current going into dishwasher. If current is ~ 11 A, then heater, ...
98 questions posted
Usually answered in minutes!
800 Questions
243 Questions
226 Questions
184 Questions
155 Questions