...water won't heat (to 150?F) and water won?t stop circulating. If NTC probe (f2/f4) has failed (opened), display will show fault code "8" immediately and testing will end shortly after water has ...
won't start. Please help. It is possible that the machine does not start off the cycle because there are errors or feedback from the inputs. For the program to start up the main program controller
won't pull up hard on the ribbon cables. 9. GENTLY pull back and forth (side to side) on the white ribbon cable on the door. It will come off with a connector. 10. Use a small flathead screwdriver
...won't finish cycle. When I turn it on it resets to 13 minutes and goes down to 1 but stays at one and never finishes. Except on rinse and hold where it goes to 1 and stays there. It would run all ...
76 questions posted
Usually answered in minutes!
800 Questions
243 Questions
226 Questions
184 Questions
155 Questions