Bosch 24 in. SHU43 Built-in Dishwasher "limit switch" Questions

Ad

Question about Electrolux Dishwashers

1 Answer

...closedif the top limit switch (FC_UP) cuts in. Appears with hood closed, if: the bottom limit switch (S3) returns to the rest position_; the top limit switch (S5) cuts in; "S3" does not cut in. ...

Ad

...Limit switch on left side of control panel tripped after 2 months. was reset and has tripped again at the 6 month mark. is this an over amp limit? Element or motor? Could be either or for that matter ...

Ad

Question about Bosch Dishwashers

1 Answer

limit switch. if open circuit, it will not start. NOTE. Make sure plug is pulled out. Bridge 2 wires out on limit switch and switch on briefly. if there is an indication of water comming in switch off

Question about Kenmore Dishwashers

1 Answer

My dishwasher will not turn on I suspect the door limit switch has malfunctioned. Need to test for continuety once the top dection of the door has been unscrewed and allowed access to the limit switch

Question about LG Dishwashers

2 Answers

...(not the electronic type) and it stop before the heating part of the cycle, it can be the overtemp limiter switch inside the base of the d/w that tripped out. the way it works is power will go to

...limit switch as the machine fills but does not stop the feed. The limit switch itself is making/breaking electical contact OK. Can you suggest a possible fault or the next diagnostic step I should ...

Question about KitchenAid Dishwashers

1 Answer

...limit switch must read a couple of Ohms or zero. If it reads infinity then the thermostat must be replaced. If the thermostat returns low impedance it may still be defective opening too soon. If ...

Question about Dishwashers

2 Answers

...for using FixYa. F19 is water in the cabinet takes too long to heat up. you can reset the heater limiter.. Reset the error message as follows: To cancel the error message, turn the rotary selector ...

Question about Dishwashers

1 Answer

...limit or flow switch problems, start testing until heating starts. Using a meter with a current coil, measure current going into dishwasher. If current is ~ 11 A, then heater, high limit and flow ...

Question about KitchenAid Dishwashers

1 Answer

...ALSO WITH WATER SWITCHED OFF, SWITCH POWER BACK ON. IF NOTHING STILL, CHECK POWER TO DOOR LIMIT. IF THERE IS POWER, EITHER THERE IS A LOOSE WIRING CONNECTION ON THE BOARD OR IT HAS AGAIN GONE

Not finding what you are looking for?
Bosch 24 in. SHU43 Built-in Dishwasher Logo

1,005 questions posted

Ask a Question

Usually answered in minutes!

Top Bosch Dishwashers Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Bosch Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...