Bosch 24 in. SHU43 Built-in Dishwasher "heat pump fault" Questions

...displays error code 1. Is this a problem with the temperature sensor, the heat pump, or the control module? 0 = No Faults 1 = Aqua Sensor Fault 2 = Heating Fault 4 = Filling Fault 8 = NTC ...

heat-pump). The control module monitors the speed & current draw of the circ pump to ensure that there is water in the sump & it is also circulating. Your machine must be less than 2 years old

...pump and fault still appears. Hi, I think both the heater and thermostat / trip switches need to be checked. If water is going in and out ok, then it seems to be waiting to heat the water. It sees a ...

...pump goes off The number of flashes indicates the fault. Reset machine by holding down the start button for 3 secs, then start a new cycle. If fault reoccurs, the number of flashes indicates fault eg ...

...fault code memory is checked in the service mode. Cause: Excess quantity of detergent or rinse aid dispensed. Excess foam has developed. Remedy: Check the dispensed quantities of detergent and rinse ...

...heat the wash and/or rinse water to a higher temperature, as the cycle calls for it. In these cycles, the dishwasher pauses after it has filled with water, waiting for the water to reach the pre-set ...

...Fault with discharge pump Discharge pump deenergized (faulty wiring or no activation by electronics) Obstruction/blocking (filters in the appliance, discharge opening in discharge trough, discharge ...

...fault. Drain Pump If lights are flashing on the control panel, the drain pump might not be working properly. For two-wire drain pump motors check them for continuity using an Ohm meter. If it's ...

...fault. Drain Pump If lights are flashing on the control panel, the drain pump might not be working properly. For two-wire drain pump motors check them for continuity using an Ohm meter. If it's ...

...fault. Drain Pump If lights are flashing on the control panel, the drain pump might not be working properly. For two-wire drain pump motors check them for continuity using an Ohm meter. If it's ...