My Kenmore Elite dryer just quit heating up...is it the heating element or possibly a fuse? The lint trap had qite a bit of lint in it..maybe it just over heated and blew a fuse? There is a thermal ...
...back in. Before you start the dryer, press the red button on the thermal sensor. Start the dryer. If the heating element doesn't come on and dryer doesn't heat, then you need to replace that
Question about Dryers
...heat sensor and a heat element. If the element is not broken, then the sensor may have failed. Sensing no heat from a broken element shuts it down. With a bad sensor, you will deliver no current to ...
Frigidaire dryer running but not heating If it is electric, then the heating element is defective and must be replaced ($45). It could also be the "over-heating" sensor. If the dryer ran too long on ...
Question about Dryers
...sensor that is not sensing when to turn the heat off, it just heats full on the whole time, you can check sensor with the power off and a meter on continuity, the sensors are located on the heating ...
...heat, take a meter and test voltage to each wire on the sensors, if one side of the sensor has voltage and the other doesnt the sensor is bad, replace it or pull the wires off and jump them or tie ...
...replacing hi temp sensor. Then sensor went out again. Reason there is another sensor that controls heating element. One is high temp, which controls the heating element from overheating. The other ...
...sensor. The no heat issue; check to make sure you don't have a blockage in the venting or in the dryer. If there is no blockage, check your element. To check if the element is not heating up, check ...
...the air setting ... none! Hi , the high temperature causes the heat sensor does not work properly , in delicate setting are having heat , the heat sensor are busted or open elements was not heating
Question about Amana Dryers
amana ned7200tw10 intermittent heating problem. New heating coil installed but dryer does not always run through heating cycle. Codes that come up are 2 and 10 when in diagnouses mode. Sensors may be ...
117 questions posted
Usually answered in minutes!
224 Questions
172 Questions
201 Questions
35 Questions
27 Questions
