Question about National Tools & Hardware - Others
...sander, which is 95% of all floor sanders. you CANNOT use a generator less than a 25KV, which is about the size of a van. All Floor sanders draw over 80 amps at start up and during floor sanding all ...
...RPM motor is the proper way, unless you simply want a slower speed sander, duh! You cannot change the motor rpm without a defenant power issue, if you change the rpm your sander will power out,
Question about Delta Tools & Hardware - Others
...sander stalls while sanding on the belt. At first I thought it was the drive belt but it is stalling the motor. Did Delta use a motor that is under powered or is this a case of of bad motor? Mine was ...
...sander 3 months to sand pistol grips. Sparks were flying from motor so replaced the brushes. Skil runs very slugis like its booging down, I think the only other possible solution is new bearings for ...
...motor start capacitor is shot. --W/D-- Did you ever get your sander to work? I have the same sander and mine is doing the same thing. I replaced the motor start capacitor and it did not fix it. ...
Question about Delta Tools & Hardware - Others
...sander will run again fine, but only for a few minutes. This usually occurs if the motor is overheating and the internal circuit breaker is tripping. After it cools down, it self resets. This can be ...
Question about Makita Tools & Hardware - Others
...sander,just replaced belt tensioner system including springs and roller but belt drive roller still keeps stopping on relatively light load even though the motor is running very good trade tool how ...
how to fix motor delta belt disc sander What is it doing or not doing, when u turn on the switch, either the switch or motor is probably bad or you have too much tension on the belt.
Question about Dewalt Tools & Hardware - Others
...so the sander is upside down 90percent of the time Impossible not to get water in the bearings and motor. It is vibrating too fast. You need air sander. Or sand dry, then wet sand the primer by
...motor, be very careful not to compress the sander body (i.e. bench vice).Dynabrade sells a rubber grip collar for this operation. then you just R and R (remove and replace) the motor and yer' good to ...
15 questions posted
Usually answered in minutes!
27 Questions
14 Questions
12 Questions