...saw is very hard to raise and lower the blade and i have removed the knob that tightens the handle so the blade does not move and its still very difficult to move the blade You need to do some ...
saw. First the blade--- you call this a hollow plank. If this is something like a hollow-core door, then the 1.5" thickness will be no problem. If you have to cut through a solid 1.5" (as you would at
blade attached. the strange thing is that it worked fine two weeks ago. When I put it away there wasn't any sign of problems. However we did have weather below freezing for those two weeks. Maybe this
...saw, model 34-440. The blade is cutting approx 2/32 to 3/32 off from front to rear causing a wide saw cerf and difficulty feeding the material through against the fence. What is the proper way to ...
...saw dust blowback around the blade right into my face. Not sure why it started that, it is several years old now. Could it be the wrong blade? It could be the particular wood you're cutting, you ...
...blade goes down fine, but when I try to raise it, it gets harder and harder until it won't move at all. It goes down easy though. it lowers easy because of the weight of the motor. What I ...
...saw dust and eventually binds up the system. Clean as best you can and the threads they turn in to raise the blade. Also check the tilt rods.Another thing to check is the joints ...
...blade won't go up or down. It looks like a retaining ring? fell off. I have the ring but don't know where to put it. The handle cranks but the gears don't move If this is a problem with a ...
...blade from the 10" Mastercraft Table Saw model # 55-6833--2 120 V motor\r\n It is not the nut I cannot get the stabalizer washers off Is it possible there's some rust in there holding it on? ...
26 questions posted
Usually answered in minutes!
27 Questions
29 Questions
23 Questions
23 Questions