...control is turned. Just checking about how to repair or get the blade to tilt again? Check to see if the hadle is just spinning on the crank shaft- tighten the set screw on the side of the ...
saws usually don't have shaft locks... i either use a piece of wood to hold the blade or a c-clamp. crank the blade all the way up, remove the plate surrounding the blade and put a wrench on the nut,,
...tighten] Please rate. Thanks jj505 Remember that the lower part is plastic so be careful how you turn it over. If the spindle is rusty put some oil on it. While it's upside down, clean out the ...
...be a result of misaligned gear or excessive buildup of dust and shavings on the gearing. Turn the
...Crank the blade up to its highest level using the knob on the side, then on the front of the saw loosen the lever and tilt the blade to whatever angle you want, using the gauge on the front as your ...
...crank it all the way out of the way and readjust, etc. Until you get it right. Make sure to tighten that lock nut when you're done. I hope this information allows you to resolve this issue. If you ...
...crank it back to check the adjustment, so make sure it changes angles easily first, by squirting some oil in there. When it get it adjusted correctly, tighten the bolts, and check the working of the ...
...safe. There should be a locking knob on the front of the crank or a locking collar behind the crank depending on which model or age of the saw that you need to tighten down to lock the arbor
473 questions posted
Usually answered in minutes!
