...move the fence to the blade, there are 2 10MM bolts on the backside that you need to loosen and then you can move the fence to square with the blade. Snug them down and move the fence and recheck let ...
...or back as the indicator rubs along the surface of the blade. Since the saw is moving along the slide, the indicator should move very little if the blade is parallel to the slide. good luck, Al ...
...blade may be flexing if you are ripping thick, or hard stock. If the saw has had a lot of use the motor bearings/bushings may be worn to the point of allowing the shaft to move horizontally. I also ...
down. There does not seem to be any way to keep the wheel in one place. When it is pusing the blade to 0 it extends away from the housing and when its pulling the blade to 45 it moves inward and makes
...that comes with the unit isnt very good. Upgrade to a good carbide blade from craftsman or even a dewalt/vermont american. Also slow your cut down an let the saw do the cutting. Hope this ...
blade I can not move the nut that hols the blade in place. I was thinking to trash it and buy new??? The tools blade is dull and needs to be changed. The problem is I can not for the life of ne remove
...with the height adjusted of the blade!! It goes a couple of turns and then it BINDS UP!!! i would say the table is twisted then, strip it down first and if you need to "bend!" it back so it ...
...blade in place. Loosen and move the part out of the way as recommended by the manufacturer. On this saw you loosen a screw and then slide the mechanism up and towards the rear. Press the spindle lock ...
...blade. Is there a way to bind the arbor so that it will not move? I have to hold the adjustment wheel and move the wood at the same time, not too safe. There should be a locking knob on the front of ...
...blade Check the threaded rods that turn to move the motor assembly up and down. These rods are sometimes oiled or greased and this just attracts saw dust and eventually binds up the ...
473 questions posted
Usually answered in minutes!