Kirby G5 Bagged Upright Vacuum "engage drive" Questions

...engage Replaced drive belt for beater bar, but now beater bar motor will not engage/turn on. Check your clutch to make sure it's engaged. There should be a knob on the foot of the vacuum that can be ...

engage I have a Kenmore Mdl.# 116.3957582 upright vaccuum cleaner, and I have checked both drive and beater belt (which both seem OK), but with self-propel engaged, I am still not getting any drive or

...drive doesn't seem to engage properly, i have noticed that there is excess movement where the handle/hoover meet. It's as if a pin or some connection has come loose or broken. thanks for any ...

...i have a g-4 kirby, the n/d is hard to shift, und the nutruel has quit functioning but the trans engages foward and reverse when pluged in and on In Kirby vacuums with tech drive there is a part ...

drive model # 116.36922502. The beater bar only engages when I lower the handle very low, almost on the ground. Any way to get the beater bar to engage normally? Thanks. Most likely you have a pinched

...engage . Turn unit on the side and inspect brush assembly for dirt, hair, etc. , also check the condition of drive belt , be sure that it is engaged with brush roller and turning freely. Also check ...

engage it to vacuum, I hear a terrible sound like something is caught in it or something. The roller on the bottom does not turn when it's engaged It sounds like the drive belt has snapped bottom left

beater bar belt too loose My beater bar v-belt doesn't seem to get tight enough when engaged. The beater bar slows or stops when it contacts the carpet, and as a result the flat drive belt spins ...

...drive lever does not engage. seems loose. I have open up the bottom of gear area and have a loose bracket,how does it go back together, need a parts diagram? that bracket is worn.....[ part number ...

...drive power. The band is stiff, so it can be a bit of a challenge to pull out far enough to get the roller back through. Use a smooth dowel or other smooth sided lever to pull band out enough to feed ...