Kirby Generation 3 Bagged Upright Vacuum "remove beater bar" Questions

...Remove beater bar by gripping the belt side of the beater bar and carefully lifting it out. • Remove worn or broken belt. • Clean beater bar and the end caps. • Loop new belt around motor shaft and ...

remove. The beater bar sits in sockets that then go ilto the vacuum frame, so note how they come out as you ease the beater bar out and slip the belt off of the bar. There's a cavity behind the beater

...remove the beater bar, so it will be much easier to put it back together. If your belt is good, it will want to come off with the beater bar, but will remain attached to the motor. If necessary, slip ...

remove the beater bar or take apart anything. As long as the beater bar spins, and there are no missing sections on the beater bar- this will work. Beater bar could also be worn down- be sure that the

...Remove the beater bar and clean it thoroughly, removing any blockages or tangles. Motor is faulty: If the motor that powers the beater bar is faulty, it may not be able to turn the bar. If the above ...

remove the beater bar belt. Replace the beater bar belt. Replace the beater bar assembly. Replace the motor shaft belt. Turn the beater bar assembly by hand to check that the unit is seated correctly.

...Remove the beater bar, making mental note as to how it comes out. You want to pay attention to the ends so you can get it back in easily. Remove whatever remains of the old belt. While you have it ...

...remove the beater bar to replace the belt, take the time to inspect the cavity behind the beater bar where the vacuum picks up. That is where vacuums usually stop up. Reassemble the vacuum. If ...

...beater bar. Remove the plate. The beater bar sits in sockets where it attaches to the vacuum, so remove carefully, making note how it comes out. This will make reassembly much easier. Place your new ...