Kirby G6 Bagged Upright Vacuum "changing hose end" Questions

...Hose End Piece <---- (This is a link so you can see the part), then it is really easy. Basically submerge the end of the hose and the coupling in hot water and once the plastic is warmed up you ...

...hose on the floor with the light at one end and look for light at the other end. I know the grip end is curved but you should be able to see some light. Check the rear port by removing the cover ...

...end of the hose, I can feel the air coming out the other end. Help!!! check the hose by putting a penny in one end and see if it comes out the other, you might have a possible clog, lux canisters are ...

...in a while, change it and check the brush roll and make sure the ends are turning freely. If no suction at the end of the hose and your hose is cleat, then the filters are clogged, check all of

changing the bag, the light stays on and the vacuum will not start. Is there a "reset" button that I am missing? First, turn dial on top of vacuum counter-clockwise so the smallest dot lines

WHEN WE USE THE HOSE ON THE VACUUM DUST AND PET HAIR COME OUT OF THE HOLE HELP A clogged hose is the most likely problem. Disconnect hose at both ends and try dropping a coin through it. If clogged, ...

...hose-- and sucking on the outlet end?-- this might assure that the hose is unplugged-- Or is there ot enough suction at the hose connection, when you remove it, and place your hand over the opening? ...

...end of the hose. This will be referred to as T1. Touch the other probe to each of the terminals/connections on the other end of the hose. These will be T3 and T4. One of them should read zero, the ...

...hose off, you just depress the clip at the end but there is no easy way to remove the connectors off of the ends, it just must get cut out and the new one pushed in and sealed Let me know if you need ...

...end of the hose it very hot water to soften the end of the hose. Then insert a screwdiver inside the plastic end piece and flex the end of the hose inward and pull the old end off. To install the new ...