...remove. Then the front of the handle asm. will come off, pull the 2 tubes off of the heater and check the inlets to make sure they are open. It gets clogged up from calcium from saop deposits, but ...
...remove handle, there are 2 screws near the bottom just under the cord wrap, then the front of the handle asm. will come off. The heater is there, put off the hoses(don't mix up) and check the opening ...
remove. Put the top part of the handle off, lay the handle down, on the front, at the top and in the center is a tab, push it in and pull the top half of the handle away from the bottom half. Then you
...front won't slide all the way to "Carpet". When I flip the vac over and peer in with a flashlight I see that the selector bar not sliding all the way to "Carpet" setting, doesn't allow the brush roll ...
...Val On the front near the bottom is a big push type button, push it in and pull the handle and bag asm. up to remove it from the power head. Then remove those 4 or 5 screws to release the top
...remove the 4 scres and nuts off of the front bearing plate and pull it out along with the armature. I can't rmember if there is enough romm after pulling it out, from the inside to cut the shaft off ...
426 questions posted
Usually answered in minutes!
625 Questions
223 Questions
207 Questions
187 Questions