Kirby G4 Bagged Upright Vacuum "commutator" Questions

Ad

Question about Vacuums

1 Answer

Arcing Commutator-Brushes The Vacuum came to a slow intermittent, burned smell. I took it apart found carbon dust all over the inside. Took the brushes out, ends were broken-splintered. I replaced the

Ad

Question about Vacuums

1 Answer

...jump...keep your fingers from moving parts. With the motor running, you will want to inspect the commutator -(where the carbon brushes push against) if a blue spark is large and wrapping around

Ad

...You can tell if bearings need to be replaced. Pull the motor and take out the rotor. Dress the commutator and get it clean. If you are lucky you can dress the commutator well enough with a hand ...

Question about Dyson Vacuums

2 Answers

...the carbon brushes in a dc07, I have removed the brush units from the motor It is possible that the commutator of the unit is dirty or scored or even out-of round. Then, there is the problem of the ...

...While you got it apart and without it plugged in, check to see that both brushes are touching the commutator. there should be sufficient spring tension to hold the brushes against the spinning part

...the base, other screws can be easily seen and removed. My problem was a badly worn bearing at the commutator end of the motor. There was so much movement that the brushes would not follow the ...

...IF MOTOR IS LOOSING CONTACT ,LIKE A BURNING SMELL. CHEERS Hi there, Most likely you have a damaged commutator. I used to change the brushes on the dyson vacuums but what i found is that it is almost ...

Question about Kenmore Vacuums

2 Answers

...fix. Small sparks coming from the brushes is normal. That would be a thin line of sparking near the commutator/brush interaction point. Large or irregular sparks are different. The commutator ...

...OF THE MOTOR WORK AS WELL. Once the motor is removed from its housing be sure to inspect the commutator surface for gapping between the segments, the lines must be parallel nor should the com ...

Question about Hoover Vacuums

1 Answer

...No diagrram is necessary unless you have dismandled. Check if the brushes are touching the mtor commutator. If not you can easily remove both the brushes and polish the surface evenly .Insert

Not finding what you are looking for?
Kirby G4 Bagged Upright Vacuum Logo

426 questions posted

Ask a Question

Usually answered in minutes!

Top Kirby Vacuums Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Paul Bade

Level 3 Expert

1818 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Kirby Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...