Northstar Pressure Washer 3000 PSI "back" Questions

...thats a bit more tricky , what i have done is remove it from engine and drain fluids and send it back to mfg for repair they send it back you install it back and put fluids back inside , whholla

i have a honda gx 390 that kicks back when i pull the rope to start The ignition timing may be too advanced . Some times if the pull start rope is not pulled hard enough it will kick back, The ...

...burned comes on and the temperature goes to desired temp and shuts off but the burner will not kick back on again. If you turn control knobs just a little bit it will kick back on, but not ...

...a similar system used on air powered tool and hoses. There is a collar that only has to be pulled back to release the washer tip. It is right under the tip just pull back toward yourself or it

...inserted into a quick connect. Simply grasp the outside of the housing holding the nozzle and pull back. The nozzle will come out. While holding the spring loaded connector back insert a new nozzle ...

...the prime pump pump leaks not to much pressure and to use the primer pump i have to lean karcher back about 45 angle; and to keep it started it helps to lean back. i replace what acts as a fuel ...

...so we unplugged it until we could get some salt. When we filled the salt container and plugged it back in, it failed to power up. The transformer is putting out the proper power, but the display is ...

...handle for my task force 2000 pressure washer apart and now I don't no where the spring is to fit back There is a spring that go's in the handle and I don't no were it's suppose to go back on It is ...

...off, the first second of spray has some pressure but none after. any help is appreciated Try and back flush the washer..Take spay nozzle off washer and back flush with hose...If any kind of sand

my pressure is very erratic it dyes down completely then goes back up for a second then back down, also the engine seems to rev up and down with it Either the pump is low on oil or your seals need ...