...chainsaw with a 42 cc engine has compression of 90 lbs does it need rebuilt it wont start 90lbs is not enough compression, so yes rebuild, or more fiscal idea is get a new one, unless you can do the ...
WON'T START .IS 70# COMPRESSION ENOUGH. SPARK AND Won't start .is 70# compression enough. Spark and fuel ok. Took off carb and cleaned it. Doesn't even fire with small dose of starting fluid 70psi ...
...42cc engine have The compression reading for a chainsaw is greatly impacted by where the schrader valve is installed on the tester too. It is a very small volume and needs to be be on the plug end of ...
chainsaw that want start. I have replaced the coil,flywheel,spark plug,and the carburetor. It has good spark and compression. Try a spray of starting fluid into the carb. If it runs reversing the fuel
roap hard to pull act like to much compression Sounds like carbon may have broken loose as is lodged between the piston and the cylinder wall.
compression test on poulan pro chain saw I got a 105 psi compression test, Is it OK ? Yes, but 100 or lower and you need to think about ring and/or cylinder, piston and ring set.
Question about Poulan Garden
42cc will not hit at all i am getting fuel check for spark, if you have spark pour a very small amount of fuel down the spark plug hole, if it runs for a few seconds and stops. You have a fuel problem
...42cc,18",PPB4218 is very hard to start and runs for a short time and then will not start when hot. It worked well first year, badly this season.Changed spark plug and cleaned fuel filter and exhaust ...
...clutch centre, there is a 19mm nut on the outside which enables yoy to jat the clutch off against compression, left hand thread.tool part no. ...
pull cord is stuck Best case is the engine is hydrolocked. Pull out the spark plug and try pulling the starter. If it turns over some saws with automatic oiling over time will let bar oil into the ...
286 questions posted
Usually answered in minutes!
583 Questions
457 Questions
170 Questions