Husqvarna Craftsman 36cc, 16 In. Gas Chain Saw "saw rev" Questions

...revs,reset idle.Then,rev saw to max revs,adjusting H screw to get max revs,then when max revs acheived,turn screw anti clockwise 1/4 turn out.That gives it enough petrol to cool the tip of the ...

...saw Try screwing the "H"screw in then out one and 1/4 turns then rev the saw up and adjust till in really start,s to rev cleanly the "L" is for low revs at idle adjust till it idles at required

...fuel tank. could this be a carburetor issue or the high/low adjustment settings on the side of the saw? As the saw runs out of fuel the revs increase due to lean fuel mix, so would guess the saw is ...

...saw rev high. More likely the throttle is sticking open after it gets hot. Check throttle position and clean. Get a can of spray carb cleaner from auto parts or the marine store. Spray away till it's ...

revs the saw will do, it is very important you do not exceed the manufacturers recommended max rpm, if the saw will not rev clean up throught the revs, increase the L screw bit at a time until it does

very quickly. Incorporated with this "red light" system is a rev limiter, so even if the saw is tuned incorrectly it will not allow the saw to over-rev due to a lean out condition and blow up the saw!

...saw cuts out on high revs Many saws made today are using electronics for engine control. If the engine rpm's starts to rev to high, the electronics in the coil will start to 'cut out' some of the ...

...is spinning without accelerating You need to reduce the minimum on your carburetor. Usually a chain saw has three screws to adjust. One is when you press the accelerator on the high revs. Then adjust ...

...saw over reves and will stick seems your over rev's may be your carb is sucking air it could be the intake gasket isn't lined up properly or the carb mounting bolts vibrated lose sometimes the over ...

...Saw will not rev fast enough to turn chain. Chain turns freely on bar.HELP PLEASE!!!!!!! There are a few things to check, if the muffler has a spark arrester gauze in the out let this may well be ...