Homelite ZR10926 16" Chain Saw "counter" Questions

...THE CHUCK FROM THE DRILL HAVING TROUBLE RE FITTING CHUCK TO DRILL Hello, the chucks have a counter clockwise thread on them. Try turning the chuck onto the drill counter clockwise (or ...

how do you remove the stud that hold the chainsaw bar on an echo chain saw, do they just unscrew, and if so is it clockwise or counter clockwise? Unscrew it in a counter clockwise direction.

how to adjust carburator on a mac 130 chain saw turn till it stops clockwise, then turn back counter clock about 1 1/2 turns. If you hear the motor sounding bogged down, turn it a bit more counter ...

...sand rolls? The spindle screw is reverse tread and you need to turn it clockwise to loosen and counter clockwise to tighten the screw. You can usually hold the spindle with your hand then turn ...

...adjust the high speed mixture screw until the engine runs at the highest RPM then turn the screw counter-clockwise about 1/8 turn. Next, turn the low speed mixture screw in whichever position

...snug. Back both out 1 full turn Now on the L needle, you adjust this while the saw is idling.. 1/4 counter clockwise increments... The H needle you adjust while pressing the throttle in and holding ...

I have inheirited a Poulan counter vibe 3400 it I have inheirited a Poulan counter vibe 3400 it doesn t have a bar and it needs a new fuel line and filter,how dependable are these saws and since I can

properly. Initial fuel mixture settings (the H and L screws) should be 1.5 - 2 complete revolutions counter clockwise from lightly seated. Sight the carb's throttle plate and adjust idle screw counter

how do i remove or change the clutch on my Poulan model 3314 chainsaw??? Remove cover,chain,& bar. Hold crank and turn clutch counter clockwise to remove.Replace in reverse order.

...with it having too much travel or force going up and down. Thanks for your help Make sure the counter balance springs are ok. Most garage doors have 2 springs to provide counter balance for the ...