Husqvarna , No.455 Rancher, 20" Gas - Powered Chainsaw "chainsaw prime" Questions

THERE IS NO GAS LEAVING THE CARB AFTER PRIMING THE PUMP OF A PULSON PP4218AVX CHAINSAW. CHANGED THE FUEL LINES AND PUMP. STILL DOESN' T START. THERE IS NO GAS LEAVING THE CARB AFTER PRIMING THE ...

...chainsaw runs for about 30 seconds then dies. I can restart it as long as I prime it, but it seems once the primed fuel is spent it dies. if the fresh air door is open to carb box, close it and you ...

...chainsaw (Homelite UT10514) will not prime fuel. I have changed the primer bulb and checked the fuel lines for damage, they seem to be in good shape. You need to make sure the lines are connected ...

...chainsaw to find all the fuel lines were in pieces< where can i find a diagram that/ll show me where they go? Shouldn't be that hard to do. Possible paths 1) Run hose from tank fitting to Carb ...

chainsaw, but it takes an hour to start it! (By which time I have a blister on my finger and my shoulder sore!) how manny times do you prime it before you try to start it? you could be flooding it, or

14" Ryobi petrol chainsaw will only run for 10 seconds 14"petrol chainsaw will run for 10 seconds and then cuts out. have had carb. off and cannot find fault but do not know enough about petrol system

Stihl 050av Chainsaw run problem wont start, only if primed through carb.... will run for about 4 seconds, dies and wont start unless primed. HEllPPp... Check the filter inside the fuel tank Check the

hard starting,but when started runs good,then put it down on ground it shuts off,always ran good before just recently had this problem. The choke isnt rattling its way back to cold start position is ...

...chainsaw prime? my chainsaw ran a complete tank of fuel. Filled it up again - would not start. Priming bulb won't fill up. Checked filter in petrol tank that's good and clean if no gas will enter ...

Poulan Pro Chainsaw, PP3516AVX Replaced fuel line since it broke from inside. Thought that was the problem since chainsaw was working great. It started with hard to start, saw the priming bulb was not