what would make a tohatsu m25c2 hard to pull start? its very hard to pull the start rope. it acts like there is too much compression of something is binding up. try taking apart pulley case that will ...
where does the knot go on the pulley of my 162 SE husqvarna chainsaw? The rope did not have a knot, it wrapped around the pulley and back over itself, if you tie a knot it may well come too close to ...
...chainsaw and I can't get it back on? Release chain tension. Loosen nut on bar, re-install chain, check for chain not binding when moved by hand, but snug on bar, tighten and you should be back in ...
Question about Husqvarna Garden
Hi i have a rancher 455 the chain sprocket on the nose end of the bar is jammed is there any way of un jamming it thanks. you can try wd-40 and work it free but they do bind when they get bent
switch wont go to off 180sthil The switch is really a fairly simple concept that simply moves a strip of metal away from a contact or allows it to connect to a contact to make or break the ignition ...
...Chainsaw engine runs normally, chain stops when placed onto wood surface. Lift it off and chain travels normally, stops at wood contact. Previously had problem with chain binding and stopping (brake ...
Chainsaw runs but won't rev up Changed the oiler put back together,will start but won't rev up kinda like it would be if the chain brake was on but checked that and that wasn't it ...
Question about Poulan Garden
...chainsaw cut stright untill it gets half way threw i replaced the cahin and bar what is wrong??? it is a P3314 modle poulan 33cc i get stareted cutting and i get about half way threw my cut and it ...
poulan pro 5020 pull start binds up the pull start binds up & won't pull the rope back in. I can remove the pull start, free it up, pull it many times over and it works just fine. but I put it back on
520 questions posted
Usually answered in minutes!
529 Questions
514 Questions
353 Questions
122 Questions
131 Questions