Sears Craftsman 7-1/4 in. Circular Saw with LaserTrac and 5 Bonus Blades "remove blade model" Questions

Removal of Blade How do you remove the blade from a SkilSaw Model 5150? turn the blade screw same direction as the blade rotation if you want to remove it.

...remove and replace blade. Thanks Without a model number I cant look for this saw, but if it is like the other mitre saws that I work on, the lower guard should have a bolt holding it in place, loosen ...

...remove the blade. ( When saw is running, the blade stop moving while the center housing is still turning ) I have tried EVERYTHING to remove the old blade without success ! While the blade is ...

remove the old blade, which way do you turn the nut? Nut is too tight to remove and not sure which way to turn it set the blade lock or use a pair of vise grips securely fastened to the blade and turn

REMOVE OR REPLACE THE BLADE ON MODEL 315.10951 quite possibly there is none . most people use a block of wood held against the blade. I've had this same circular saw since new (the 80's). There is not

...MODEL 2400B HOW DO I CHANGE THE BLADE There is a push-in lever located between the handle and saw blade. Push in lever and rotate blade until blade locks. Once blade is locked, loosen nut located in ...

...are bad. What you can do is remove the blade and unplug the saw. locate where the screws holding the bearing cover are and remove them to get to the gear and check it. Let me know if you need more ...

remove the bolt in the center of the blade. the blade will slip off then. a wrench for this should have come with your saw. if not, use any properly sized wrench. if needed, pull back the blade guard,

...blade rotation and remove the hex bolt and OUTER flange lift the guard and put the blade on the spindle. Reinstall the outer flange and tighten the hex bolt, generally newer saws have a spindle lock ...

...remove the blade bolt, you are going to have to immobilize the armature to get it off.  Remove the cap on the motor housing so you can remove or relieve the spring pressure on the brushes.  ...