Question about Black & Decker Tools & Hardware - Others
...Nothing changes when the batteries are put on the charger. Any suggestions? change batteries, your charger should indicate wheather you battery is good or noot on the pause inbetween
...governed by the number of charges. The only sure way of knowing is to have another battery or charger that you know does work. if it is the battery its normally cheaper to buy another complete
Question about Vector Tools & Hardware - Others
battery charger it said it was full and running at 9.1 when it should be running at around 12 then said error f03. so what does that mean and how do i fix the problemI? It means the battery charger is
Question about Vector Tools & Hardware - Others
...volt battery starter not working I plugged my charger in and it doesn't work. no lights, no charge to indicate its on. plugin wall charger warm. Replace the chargers as I said in my last
...charger or the battery? Have you tried other batteries? If the battery is bad (they do go bad over time) then the charger wont work. But chargers also go bad too and can't be fixed. I've had four ...
Question about Black & Decker Tools & Hardware - Others
...battery charger? My charger has a fuse located on the circuit board inside the unit....when mine stopped working, it was the fuse...replaced it and it is working fine for one battery, the other blows ...
...to the battery terminals it would charge up? The charger is bad. A resistor probably blew inside the circuit board. The board is not replaceable. You will need to buy a new charger. They cost about ...
Question about Makita Tools & Hardware - Others
...battery that is pretty much dead, the Makita charger will never fully charge it and so it blinks. My newer battery charged up in 1/2 an hour but my old-as-the-hills one just keeps on blinking. I ...
...battery charger want charge Batterys have a life span associated with them. Typically about 2 years depending on how often you use them and your charging habits. The newer batteries(in the past 4 ...
...battery charger to mains supply and switch on. 2) Set the scale on the test meter to 200 volts DC Voltage (V--) 3) Insert the test meter probe wires in the sockets on the meter marked "Com" (black) ...
7 questions posted
Usually answered in minutes!
3 Questions