...clean spark plug, and a clean air filter. The spark, the fuel, and the air all contribute to an easy start and a good idle. If you havn't changed the spark plug lately do so, same with the air
Question about Tecumseh Tools & Hardware - Others
...then stalls. I have changed plug, adjusted valves and replaced fuel supply lines/filter, along with the new carb. What could be problem? check to see if air filter or supply tube is plugged bad ...
Just replaced an inducer motor on my York 80 furnace. Now it shuts off and blinks 8 times, due to flame shuts down 5 times. I cleaned a flame sensor as well to no avail. Does any one have other ...
...fuel system clean filter hoses etc. It has clean fuel in float bowls, jet and metering rod are clean, plugs are almost new and clean. I am thinking maybe something to do with oil pressure switch (it ...
Question about Briggs & Stratton Tools & Hardware - Others
...filter, fuel filter. Compression is 150 psi on both cylinders Anti-foul plug adapters might be a temporary solution (treats the symptom and not the cause). Personally, I would take it to a good, ...
...but.I'd change the plug. clean the air filter. check the fuel screen in the fuel tank, make sure it is fresh fuel, if none of this works I would think your carb is still dirty or out of
...the air filter or replace it check that fuel injection lines and port holes are not plugged if that does not work go to dump and get a new one cheap from discarded mowers that had a cheap broken
Question about Briggs & Stratton Tools & Hardware - Others
filter housing to carb or carb to black block or block to intake maybe leaking. fuel shut off solenoid could be going bad. choke cable adjustment. there is crank case breather under air filter housing
Question about Briggs & Stratton Tools & Hardware - Others
...run for about one minute fuel pump is working but it seems to not be getting fuel through carburator Sounds like the filter may be plugged up..not expensive change it see if that helps..good
Question about Honda Tools & Hardware - Others
...fuel in my filter and exhaust caused by sticking float, will this prevent me from pulling the cord? I stripped the carb down following fuel in filter and exhaust and checked the float in the float ...
126 questions posted
Usually answered in minutes!
36 Questions
9 Questions