Craftsman Mechanics Air Tool Kit Impact Wrench/ratchet "gun" Questions

IR 261 air wrench vanes sticking I use IR 261 guns. We tighten 1000 1/2" bolts a day per gun. I cannot keep a gun running for more than a few days before the vanes stick into the rotor and you can't ...

need rebuilding kit for air gun I have a Snap On AT300C 3/8" drive impact gun. I absolutely love this gun and do NOT want to part with it, but it is showing it's age and the anvil head broke causing ...

...to 3/8 id hose set the regulator at 90 psi, that is the recommended pressure for most 1/2 inch guns. the guns effectiveness peaks around 90 psi. more than that could damage the gun. ...

craftsman 1/2' impact gun i own a craftsman 1/2' impact gun model 875198641. the hammer pin broke. i replaced the pin and reassembled the gun. what lube oil is used in the hammer housing and how much ...

...is pulled air blows out a vent at the bottom and the anvil doesn't rotate. If debris enter the gun, over time the vanes will not move into proper positon and react to air-flow. Vanes can become ...

my 1/2" pneumatic impact gun runs at full rpms but you can stop it with your hand.......what do i need to check Is this an expensive gun?If not this might be normal.If not the hammer in the gun is ...

My Aircat 1404BG impact gun stopped working. When I squeeze the trigger of my Aircat 1404BG impact gun, air disperses through the exhaust, but it is not working. I took it apart to see if anything is ...

how do i get more torque out of my craftsman impact gun? buy a better gun the cheap ones dont have any power

Model No. 875191182? Just put 3-5 drops of air tool oil down the air inlet coupler and then run the gun for 5 seconds. Do this everyday that you run the gun for best results

...neck of my Ive noticed hairline crack in the neck of my Model 10 cup lid, where it attaches to the gun. Will this make gun lose pressure? Is it safe to continue to use the lid cap this way? This has ...